Press connector system with plastic or multi-layer pipes for potable water and heating installations. Press connectors with PPSU support body to ensure the leak tightness and mechanical strength of the connection.
Multi-layer pipe exterior colour white suitable for potable water and heating installations
Flexible plastic pipe exterior colour natural suitable for potable water and heating installations
Marking Manufacturer, pipe dimension or system name, batch, green dot on press end, system approvals
Press connector with SC‑Contur Inadvertently unpressed connections are noticed immediately during a leakage test. Viega guarantees the detection of unpressed connections in the following pressure ranges: min. water pressure: 0.1 MPa / 100 kPa / 1 bar / 14.5 PSI max. water pressure: 0.65 MPa / 650 kPa / 6.5 bar / 94.3 PSI min. air pressure: 22 hPa / 2.2 kPa / 22 mbar / 0.3 PSI max. air pressure: 0.3 MPa / 300 kPa / 3 bar / 43.5 PSI
Tools The functional safety of Viega press connector systems depends primarily on the faultless condition of the press tools used. Viega recommends the use of Viega press tools for pressing Viega press connectors.
Areas of application Potable water
Note The press connector system Viega Speedpress is suitable for the creation of potable water installations according to DIN 1988‑200 and EN 806‑2 in consideration of the selection of material in accordance with DIN EN 12502‑1 and according to the evaluation basis for metallic materials in contact with potable water of the Umweltbundesamt (UBA) (German Federal Environment Agency). When used for other areas of application and when in doubt about the right selection of material, please contact Viega. The system components should be protected against high concentrations of chloride generated by both the medium and by external factors.
Note – Standards and approvals KIWA certified and tested in acc. with DIN EN ISO 22391 and DIN EN ISO 21003.
Operating conditions for potable water installations operating temperature max. 70 °C / 158 °F operating pressure max. 1.0 MPa / 10 bar / 145 PSI Irrelevant of the flow direction, mixed installations are permitted.
Material press connector Brass PPSU
Subject to change without prior notice! Latest Z- and installation dimensions as well as further technical information can be found on the Viega website and have to be checked before purchase, planning, construction work and use. Our products are continuously optimised.
This product description contains important information on choice of product and system, mounting, commissioning as well as intended use and, if required, on maintenance measures. This information on products, their features and application techniques is based on currently valid standards in Europe (e.g. EN) and/or in Germany (e.g. DIN/DVGW). Some passages in the text may refer to technical regulations in Europe/Germany. These should be considered as recommendations for other countries where no corresponding national requirements exist. The relevant national laws, standards, regulations, directives and other technical provisions take priority over the German/European directives specified in this product description: The information herein is not binding for other countries and regions and should be understood as recommendation.